Toro 21356 Manuel De L'utilisateur page 11

3
Unfolding the Handle
No Parts Required
Procedure
WARNING
Unfolding the handle improperly can damage the cables, causing an unsafe operating
condition.
• Do not damage the cable(s) when folding or unfolding the handle.
• Ensure that the cable(s) are routed to the outside of the handle.
• If a cable is damaged, contact an Authorized Service Dealer.
Important:
Remove and discard the protective plastic sheet that covers the motor and any other
plastic or wrapping on the machine.
1. Unlock the handle locks (A of
2. Move the handle rearward to the operating position (B of
3. Hold the handle while engaging the handle locks to avoid pinching your hands.
4. Engage the handle lock until the pin clicks in place to lock the handle into the operating position (C of
Figure 5).
Figure 5).
Figure 5
9
Figure 5).
g332165