Bosch UniversalDistance 30 Notice Originale page 27

If no button on the measuring tool is pressed for approx.
5 min, the measuring tool will switch off automatically to pre-
serve the non-rechargeable batteries.
All stored values are retained when the tool is switched off.
Measuring Process
Once switched on, the measuring tool is in the length measure-
ment function.
Once the measuring tool has been switched on, the rear edge
of the measuring tool is selected as the reference level for
measurement. You can change the reference level. (see "Se-
lecting the Reference Level", page 28)
Apply the measuring tool to the point at which you want to
start the measurement (e.g. wall).
Briefly press the
Aim the laser point at the target.
Press the button again to start the measurement.
Once the measurement process is complete, the laser beam
will switch off. For a further measurement, repeat this pro-
cess.
Measured values or end results can be added or subtracted.
In the continuous measurement function, the measurement
begins immediately after the first press of the
For more information, you can access the online op-
erating instructions at www.bosch-pt.com/manuals
The measuring tool must not be moved during a meas-
urement (with the exception of the continuous meas-
urement function). Therefore, place the measuring tool, as far
as this is possible, against or on a firm stop or supporting sur-
face.
Bosch Power Tools
button to switch on the laser.
1 609 92A 8CZ | (31.03.2023)
English | 27
button.