Tools Required - Husqvarna ST 424 Manuel D'utilisation

Handle knobs (2)
Locknut 3/8 (1)
Locknut 3/18-16 (1)
(ST 424/427/430 ) Cable holder (1)
Shear pins ¼-20 x 1.81 (6)
Locknuts ¼-20 (6)
Locknut 5/16-18 (1)
Locknut ¼-20 (1)
Nylon washer (1)
Carriage bolt 5/16-18 x 5/8 (1)
Roll pin (1)
Release lever (1)
Discharge chute lever
Spring (1)
876 - 011 - 11.05.2020
Shoulder bolt ¼-20 (1)

Tools required

• 3/8 in. wrench (1)
• 7/16 in. wrench (1)
• 1/2 in. wrench (1)
• 9/16 in. deep socket (1)
To install the handle
1. Lift the upper handle to the operation position.
2. Adjust the handle position to one of the holes
(C).
9