Husqvarna ST 424 Manuel D'utilisation page 11

7. Adjust the left and right discharge chute cables.
To adjust the left and right discharge chute
See
cables on page 24 .
To install the remote control for the
discharge chute deflector
1. Attach the cable bracket (A) to the discharge
chute with a carriage bolt (B) and a 5/16-18
locknut (D). Tighten the bolt.
2. Install the cable eyelet (E) to the discharge chute
deflector (F). Use a shoulder bolt (G), a nylon
washer (C), and tighten with a ¼-20 locknut (K).
The cable eyelet will be loose on the shoulder
bolt.
3. Attach the spring (L) between the hex nut (M) on
the rotator head and the hole on the discharge
chute deflector.
G
C
E
K
D
A
To install the speed control cable
1. Put the drive speed lever in the neutral position.
2. Attach the speed control cable (B) to the drive
speed lever with a retaining pin.
3. Attach the speed control cable to the bracket (C)
with 2 ½ in wrenches. Make sure that the drive
speed lever stays in the neutral position.
4. Remove the screw and wing nut (A) on the
bellcrank to let the bellcrank move.
876 - 011 - 11.05.2020
F
L
M
B
To attach replacement shear pins
•
A
Attach the replacement shear pins on the cover
of the remote control or on the battery box.
B
C
11