Husqvarna ST 424 Manuel D'utilisation page 10

A
C
3. Put the bolt (B) through the hole (C).
4. Attach the knob (A) to the bolt and tighten the
knob.
5. Attach more carriage bolts (B) and handle knobs
(A) to attach the upper handle to the lower
handle.
To install the discharge chute
1. Put the deflector assembly for the discharge
chute on the top of the discharge chute. The
discharge opening must point to the front of the
product.
2. Put the rotator head (A) on the discharge chute
bracket (J).
3. Align the pins below the rotator head with the
holes in the discharge chute bracket.
4. Put the rotator head on the pin (E), and the
threaded stud (G) on the bracket (F).
10
B
A
J
I
H
G
5. Attach a locknut (B) on the threaded stud and
tighten.
6. Attach the square retainer (I) with a locknut (H).
7. Put the cables through the hook cable slot.
• For ST 424, ST 427, ST 430 use hook cable
slot (C).
• For ST 424T, ST 427T, ST 430T use hook
cable slot (K).
To install the discharge chute lever
and the release cable
1. Push the knob (D) down on the discharge chute
lever. Use a rubber mallet if it is necessary.
2. Attach the release cable to the discharge chute
lever at connection (A).
C
B
A
3. Put the release cable in the groove (B) on the
discharge chute lever.
4. Install the cable barrel fitting (F) to the release
lever (E).
5. Install the release lever (E) to the discharge
chute lever and attach it with the roll pin (C).
6. Adjust the release cable. See
release cable of the discharge chute on page
24 .
B
C
D
K
E
F
D
E
F
To adjust the
876 - 011 - 11.05.2020