Husqvarna ST 424 Manuel D'utilisation page 24

If the adjustment does not resolve the problem,
replace the auger belt. See
belt on page 22 .
To adjust the release cable of the
discharge chute
1. To adjust the release cable, turn the cable
adjuster until the release lever of the discharge
chute does not move freely.
To adjust the left and right discharge
chute cables
1. Put the discharge chute lever in the center
position.
2. Turn the cable adjusters until the discharge chute
points straight forward, and the cables are tight.
24
To install the auger
3. Loosen the cable adjusters ¼ turn to make the
cables less tight.
To remove the wheels
1. Remove the wheel pin (A) and the retainer pin
(B).
2. Remove the wheel from the axle (C).
A
B
To adjust the tension of the
continuous tracks (for ST 424T/
427T/430T only)
Note: Tools that are necessary for this task: a 9/16"
deep socket, a 9/16" wrench and a 5 kg (10 lbs)
weight.
1. Loosen the locking screw (A) 1 turn.
C
876 - 011 - 11.05.2020