Husqvarna ST 424 Manuel D'utilisation page 22

A
4. Tighten the idler pulley nut (A).
5. Press and then release the drive speed control
lever. If the drive belt has tension when the drive
speed control lever is released, move the idler
pulley away from the drive belt to release the belt
tension.
6. Install the belt cover. See
on page 21 .
To remove the auger belt (for ST
424/427/430 only)
1. Remove the 5/16'' nut and the cable cover (E)
from the frame.
A
E
2. Remove the top 5/16'' bolts and the lower ¼''
bolts (D) from the 2 sides of the frame. Do not
discard the bolts.
3. Loosen but do not remove the lower 5/16'' bolts
(C) on the 2 sides of the frame.
4. Remove the auger belt (B) from the engine pulley
(A).
5. Tilt the rear section down. The front section tilts
forward at the same time. The bottom bolt is a
hinge between the front and rear sections.
6. Put a wooden block below the hinge point to set
the product in the tilted position.
22
B
To install the belt cover
B
C
D
7. Move the auger brake arm and remove the auger
belt (B) from around the auger brake arm.
To remove the auger belt (for ST 424T/
427T/430T only)
1. Remove the 5/16'' nut and the cable cover (E)
from the frame.
A
F
E
2. Remove the top 5/16'' bolts from the 2 sides of
the frame. Do not discard the bolts.
3. Remove the lower 5/16'' bolts (C) on the 2 sides
of the frame.
4. Remove the auger belt (B) from the engine pulley
(A).
5. Use the adjustment lever for the auger bucket to
tilt the rear section down. The front section tilts
forward at the same time. The bottom bolt is a
hinge between the front and rear sections.
6. Put a wooden block below the hinge point to set
the product in the tilted position.
7. Move the auger brake arm and remove the auger
belt (B) from around the auger brake arm.
To install the auger belt
1. Move the auger brake arm (G). Put the auger
belt around and in the groove of the auger pulley
(E).
B
C
D
876 - 011 - 11.05.2020