Throttle Control; To Stop The Product - Husqvarna ST 424 Manuel D'utilisation

Throttle control

Note: If the snow is wet or heavy, use the fast or
boost modes.
The throttle control adjusts the engine speed. It has
3 modes: boost, fast and slow.
A B
• Boost (A): to increase speed when the product is
operated but does not throw snow, or to increase
the distance that snow is thrown.
• Fast (B): standard operation
• Slow (C): to decrease the distance that snow is
thrown, or to decrease engine noise
To use the throttle control
• Turn the throttle control to change the engine
speed.
To use the heated handles
• Push the switch to I to start the heated handles.
• Push the switch to O to stop the heated handles.

To stop the product

1. Turn the key to the STOP position.
14
C
2. Remove the ON/OFF key.
To adjust the discharge chute and
the discharge chute deflector
1. Push the release lever (B) on the discharge
2. Move the remote control lever (C) to adjust the
To adjust the skid plates
The skid plates prevent damage to the bottom of the
snow thrower. Adjust the skid plates (A) when the
locknut (B) is loose, or the skid plate is not at the
correct distance from the ground. No adjustment is
necessary for standard installation.
1. Loosen the locknut (B) with a 13 mm (½ in.) open
2. Move the skid plates (A) up or down.
chute lever (A) and adjust the discharge chute to
the left or right position.
snow throwing distance.
a) Move the remote control lever up to decrease
the snow throwing distance.
b) Move the remote control lever down to
increase the snow throwing distance.
wrench.
a) On flat surfaces set the distance between the
scraper bar and the ground to 5-6 mm
(0.2-0.25 in).
b) On rough surfaces set the skid plates (A) in a
position where the scraper bar is above the
top of the ground.
A
B
C
876 - 011 - 11.05.2020