Toro Titan X4850 Manuel D'utilisation page 55

3. Remove the damaged or worn discharge
deflector.
4. Position the new discharge deflector with the
bracket ends between the welded brackets on
the deck as shown in
5. Install the spring onto the straight end of the rod.
6. Position the spring on the rod as shown in
79 so that the shorter spring end comes from
under the rod before the bend and going over
the rod as it returns from the bend.
7. Lift the loop end of the spring and place it into
the notch on the deflector bracket
Figure 79
1. Rod and spring assembly
installed
2. Loop end of the spring
installed into the notch in
the deflector bracket
8. Secure the rod and spring assembly by twisting
it so that the short end of the rod is behind the
front bracket welded to the deck
Important:
The grass deflector must be
spring loaded in the down position. Lift the
deflector up to test that it snaps to the full
down position.
9. Install the cotter pin into the end of the rod
(Figure 78).
Figure 79.
Figure
(Figure 79).
g297573
3. Rod, short end, moved
behind the mower bracket
4. Short end, retained by
mower bracket.
(Figure 79).
Cleaning
Cleaning the Suspension
System
MyRide Machines Only
Note:
Do not clean the shock assemblies with
pressurized water (Figure
Disposing of Waste
Engine oil, batteries, hydraulic fluid, and engine
coolant are pollutants to the environment. Dispose of
these according to your state and local regulations.
53
80).
Figure 80
g195820