Toro Titan X4850 Manuel D'utilisation page 28

Operating the Choke
Use the choke to start a cold engine.
1. Pull up the choke knob to engage the choke
before using the key switch
2. Push down the choke knob to disengage the
choke after the engine has started
Figure 30
1. O position
N
(Figure 30).
(Figure 30).
g295540
2. O position
FF
Operating the Key Switch
1. Turn the key to the S
Note:
When the engine starts, release the key.
Important:
Do not engage the starter motor
for more than 5 seconds at a time. If the
engine fails to start, wait 10 seconds between
attempts. Failure to follow these instructions
can burn out the starter motor.
Note:
You may need multiple attempts to start
the engine when you start it the first time after
the fuel system has been without fuel completely.
2. Turn the key to the S
engine.
26
position (Figure
TART
Figure 31
position to shut off the
TOP
31).
g008947