Toro Titan X4850 Manuel D'utilisation page 29

Starting the Engine
Note:
A warm or hot engine may not require choking.
Important:
Do not engage the starter for more
than 5 seconds at a time. Engaging the starter
motor for more than 5 seconds can damage the
starter motor. If the engine fails to start, wait 10
seconds before operating the engine starter again.
Figure 32
Shutting Off the Engine
1. Disengage the blades by moving the
blade-control switch to the O
2. Engage the parking brake.
3. Move the throttle control to between the half and
full throttle position.
4. Turn the key to the O
the key.
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while
it is unattended.
Always remove the key and engage the
parking brake when leaving the machine
unattended.
Using the Motion-Control
Levers
g297307
1. Motion-control
lever—N
EUTRAL
position
2. Center, unlocked position
3. Forward
27
position.
FF
position and remove
FF
Figure 33
4. Backward
-
LOCK
5. Front of machine
g004532