Télécharger Imprimer la page

Toro Titan X4850 Manuel D'utilisation page 25

Masquer les pouces Voir aussi pour Titan X4850:

Publicité

Les langues disponibles

Les langues disponibles

Operate the engine only in well-ventilated areas.
Exhaust gases contain carbon monoxide, which
is lethal if inhaled.
Never leave a running machine unattended.
Attach towed equipment to the machine only at
the hitch point.
Do not operate the machine unless all guards
and safety devices, such as the deflectors, are in
place and functioning properly. Replace worn or
deteriorated parts when necessary.
Use only accessories and attachments approved
by Toro.
This machine produces sound levels in excess
of 85 dBA at the operator's ear and can cause
hearing loss through extended periods of
exposure.
1. Wear hearing protection.
Clean grass and debris from the cutting unit,
drives, muffler, and engine to help prevent fires.
Start the engine with your feet well away from the
blades.
Be aware of the mower discharge path and direct
the discharge away from others. Avoid discharging
material against a wall or obstruction because the
material may ricochet back toward you.
Stop the blades, slow down the machine, and use
caution when crossing surfaces other than grass
or when transporting the machine to and from the
operating area.
Do not change the engine governor speed or
overspeed the engine.
Children are often attracted to the machine and
the mowing activity. Never assume that children
will remain where you last saw them.
Keep children out of the operating area and under
the watchful care of a responsible adult other than
the operator.
Be alert and shut off the machine if children enter
the operating area.
Before backing up or turning the machine, look
down and all around for small children.
Do not carry children on the machine, even when
the blades are not moving. Children could fall
off and be seriously injured or prevent you from
Figure 21
safely operating the machine. Children who have
been given rides in the past could appear in the
operating area without warning and be run over or
backed over by the machine.
Slope Safety
Slopes are a major factor related to loss of control
and rollover accidents, which can result in severe
injury or death. The operator is responsible for
safe slope operation. Operating the machine on
any slope requires extra caution. Before using the
machine on a slope, do the following:
– Review and understand the slope instructions
in the manual and on the machine.
– Use an angle indicator to determine the
approximate slope angle of the area.
– Never operate on slopes greater than 15°.
– Evaluate the site conditions of the day to
determine if the slope is safe for machine
operation. Use common sense and good
judgment when performing this evaluation.
Changes in the terrain, such as moisture, can
quickly affect the operation of the machine on
g229846
a slope.
Identify hazards at the base of the slope. Do
not operate the machine near drop-offs, ditches,
embankments, water, or other hazards. The
machine could suddenly roll over if a wheel goes
over the edge or the edge collapses. Keep a safe
distance (twice the width of the machine) between
the machine and any hazard. Use a walk-behind
machine or a hand trimmer to mow the grass in
these areas.
Avoid starting, stopping, or turning the machine on
slopes. Avoid making sudden changes in speed or
direction; turn slowly and gradually.
Do not operate a machine under any conditions
where traction, steering, or stability is in question.
Be aware that operating the machine on wet
grass, across slopes, or downhill may cause the
machine to lose traction. Loss of traction to the
drive wheels may result in sliding and a loss of
braking and steering. The machine can slide even
if the drive wheels are stopped.
Remove or mark obstacles such as ditches, holes,
ruts, bumps, rocks, or other hidden hazards. Tall
grass can hide obstacles. Uneven terrain could
overturn the machine.
Use extra care while operating with accessories or
attachments, such as grass-collection systems.
These can change the stability of the machine
and cause a loss of control. Follow directions for
counterweights.
If possible, keep the deck lowered to the ground
while operating on slopes. Raising the deck while
23

Publicité

loading