Toro Titan X4850 Manuel D'utilisation page 19

4. Sit on the seat, engage the parking brake,
move the blade-control switch (PTO) to the O
position, and move the motion-control levers
to N -
EUTRAL LOCK
While the engine is running, center either
motion-control lever and move it forward or
reverse; the engine should shut off. Repeat for
other motion-control lever.
5. Sit on the seat, disengage the parking brake,
move the blade-control switch (PTO) to the O
position, and move the motion-control levers to
N - position. Try starting the engine;
EUTRAL LOCK
the engine should not crank.
Positioning the Seat
The seat can move forward and backward. Position
the seat where you have the best control of the
machine and are most comfortable
position. Start the engine.
(Figure 8).
Figure 8
Adjusting the MyRide™
FF
Suspension System
Machines with MyRide Only
The MyRide™ suspension system adjusts to provide a
smooth and comfortable ride. You can adjust the rear
springs to quickly and easily change the suspension
system. Position the suspension system where you
FF
are most comfortable
The slots for the rear springs have detent positions for
reference. You can position the rear springs anywhere
in the slot, not just in the detent positions.
The following graphic shows the position for a soft or
firm ride and the different detent positions
1. Firmest position
2. Softest position
g027632
Note:
Ensure that the left and right springs are
always adjusted to the same positions.
17
(Figure 9 and Figure 10).
(Figure
Figure 9
3. Detents in the slots
9).
g195744