Toro Titan X4850 Manuel D'utilisation page 52

Leveling the Mower Deck
1. Set the anti-scalp rollers to the top holes or
remove them completely for this procedure; refer
to Adjusting the Anti-Scalp Rollers (page
2. Set the height-of-cut lever to the 76 mm (3 inch)
position; refer to
(page 30).
3. Place 2 blocks, each having a thickness of 6.6
cm (2-5/8 inches), under each side of the front
edge of the deck but not under the anti-scalp
roller brackets (Figure
4. Place 2 blocks, each having a thickness of 7.3
cm (2-7/8 inches), under the rear edge of the
cutting deck skirt, 1 on each side of the cutting
deck (Figure 74).
Figure 74
1. Wood block—6.6 cm
(2-5/8 inches) thick
2. Wood block—7.3 cm
(2-7/8 inches) thick
5. Loosen the adjustment bolts on all 4 corners so
that the deck is sitting securely on all 4 blocks
(Figure 75).
Adjusting the Anti-Scalp Rollers
74).
3. Front edge
30).
1. Deck-lift arm
2. Chain
6. Ensure that there is tension on all 4 chains
(Figure
7. Tighten the 4 adjustment bolts
8. Ensure that the blocks fit snugly under the deck
skirt and that all bolts are tight.
g297501
9. Verify that the deck is level by checking the
side-to-side level and front-to-rear blade slope;
repeat the deck leveling procedure if necessary.
50
Figure 75
3. Hook
4. Adjustment bolt
75).
g297515
(Figure 75).