Insertion In Existing Fireplace - Ravelli Rbh 150 V Manuel D'utilisation Et D'entretien

Insertion in existing fireplace

To install the appliance in an existing fireplace compartment, proceed as follows:
step action
1 Unscrew and remove the lower frame
2 Unscrew the nuts and remove the fireplace from the slide (detach the hoses from the slide if necessary)
3 Unscrew and remove the slide from the support
4 Fix the slide to the support surface
5 Pull out the slide guides and place the fireplace on the guides
6 Tighten the nuts for fixing the fireplace to the guides and close the fireplace again
7 Check the correct functionality of the coupling and the release.
You can hear when coupling occurs, as it makes a "clicking" sound.
1
3
Use and maintenance manual RBH 150 V - RBH 200 V
x4
x8
2
x4
4
Rev.2 15/07/2021
Pag.33
x8
MAX 10mm
EN