Stopping Therapy - arjo Flowtron ACS900 Notice D'utilisation

Stopping Therapy

inflated twice in succession and then the calf
(or calf & thigh) garment is inflated, as follows.
1. Inflate the foot garment.
2. Deflate the foot garment.
3. Repeat the inflation of the foot garment.
4. Deflate the foot garment.
5. Inflate the calf (or calf & thigh) garment.
6. Deflate the calf (or calf & thigh) garment.
7. This cycle of garment inflations repeats from
step 1 until the therapy is stopped.
To stop the therapy and put the pump into Standby,
press and hold the Middle Control button for
approximately 2 seconds until the Standby screen is
displayed (refer to "Standby Screens" on page 12)
and then release it.
The LEDs on the front and underside of the pump are
extinguished.
If the pump stays in Standby, then:
1. After 5 minutes the LCD display backlight is
dimmed.
2. After a further 10 minutes (15 minutes total) the
pump automatically goes into an "Off" state:
• On mains power, the LCD screen backlight
will be extinguished and only the mains power
and battery indication icons will be displayed.
• On battery power, the pump will power down
and the screen will be blank.
The Mains indicator above the Power button will
remain green if the pump is connected to the
mains power and extinguished if the mains power
is disconnected.
To switch off the pump, press and hold the Power
button for approximately 2 seconds. Then,
• On mains power, the LCD screen backlight will be
extinguished and only the mains power and
battery indication icons will be displayed.
• On battery power, the pump will power down and
the screen will be blank.
16