Standby Screens - arjo Flowtron ACS900 Notice D'utilisation

Major Revision

Standby Screens

3. During the last part of the initialisation process,
the software version will be displayed,
comprised of:
• Major revision in top left.
• Minor revision in bottom right.
This screen shows software version "V1.047".
4. At the end of the successful diagnostic test, the
"No Garments" Standby screen is displayed.
5. The Patient Run Hours value can now be reset
by pressing the Right Control button (refer to
"Resetting the Patient Run Hours" on page 19).
6. The alarm volume can also be set by pressing
the Left Control button (refer to "To Change the
Audible Alarm Volume Setting" on page 18).
The "No Garments" Standby screen (above) shows
two leg icons on the left side of the LCD screen with
no garment outlines on them, indicating that no
garments are currently connected to either tubeset.
The Start Therapy icon does not appear until at
least one garment is connected to a tubeset
connector.
Apply the prescribed Arjo garment(s) to the patient
by following the instructions included in the garment
packaging.
Do not re-use the garments. Do not use the
garments on multiple patients.
Connect the garment(s) to the pump by pushing the
garment connector firmly into the pump tubeset
connector until it "clicks".
The pump LCD screen will show which garments are
connected to each tubeset connector: the garment
connector with the blue push button is "1" and the
one with the orange push button is "2" (refer to
"Garment Type and Inflation Indication" on page 8).
12
Minor Revision