Beurer BM 35 Mode D'emploi page 20

Now tighten the free end of the cuff,
but make sure that it is not too tight
around the arm and close the hook-
and-loop fastener. The cuff should be
fastened so that two fingers can fit
under the cuff.
Now insert the cuff line into the con-
nection for the cuff connector.
This cuff is suitable for you if the
index mark ( ) is within the OK
range after fitting the cuff on the
upper arm.
If the measurement is performed on the right upper arm,
the line should be located on the inside of your elbow.
Ensure that your arm is not pressing on the line.
Blood pressure may vary between the right and left arm, which
may mean that the measured blood pressure values are differ-
ent. Always perform the measurement on the same arm.
If the values between the two arms are significantly different,
please consult your doctor to determine which arm should be
used for the measurement.
Important: The instrument should only be operated with the
original cuff. The cuff is suitable for an arm circumference of
22 to 36 cm.
A larger cuff for upper arm circumferences from 30 to 42 cm is
available from retailers or the service address under order no.
162.973.
Adopting the correct posture
• Rest for approx. 5 minutes before each measurement. Other-
wise there may be divergences.
• You can perform the measurement either sitting or lying down.
Always make sure that the cuff is on a level with your heart.
• To carry out a blood pressure measurement, make sure you
are sitting comfortably with your arms and back leaning on
something. Do not cross your legs. Place your feet flat on the
ground.
• In order not to distort the result, it is important to keep still
during the measurement and not talk.
Select memory
Switch on the blood pressure monitor with the
Select the required memory space by pressing the function key
+. You have two memories (60 memory spaces each) in order
to save the test results of 2 different people separately, or else
save measurements in the morning and evening separately.
Performing the blood pressure measurement
• Put on the cuff as described previously and assume the
position in which you want to carry out the measurement.
20
button.