Ryobi RBS-5518 Mode D'emploi page 23

9. UPKEEP AND MAINTENANCE
Warning!
Before any upkeep or cleaning operation:
• Unplug the machine.
• Remove the power plug.
• Wait until the saw has stopped.
After your upkeep or cleaning operations, re-set the safety device and check that it is operating properly.
You must always replace damaged parts, especially the safety device, with genuine factory parts since parts that have not
been checked and approved by the manufacturer can cause unpredictable damage.
Only qualified staff is authorised to carry out maintenance and repair work other than the operations described in this section.
9.1 CHANGING THE SAWBLADE (Fig. 21 - 22)
Warning!
You can cut yourself even when the sawblade is not moving. Wear gloves to change the sawblade.
Only use appropriate sawblades.
1. Loosen the two screws (39) and remove the guide plate (40).
2. Open the two doors.
3. Direct the upper sawblade guide (41) downwards.
4. Loosen the adjustment knob (42) until the sawblade is loose.
5. Remove the sawblade and pass the slide through the slit in the table (43) in the upper sawblade guide (44), the sawblade
opening (45) and rack.
6. Install the new sawblade. Make sure each element is in the correct position: The teeth of the saw must point to the front
(towards the door) of the saw.
7. Install the sawblade in the middle of the rubber tires.
8. Tighten the adjustment knob until the sawblade no longer slides.
9. Close the two doors.
10.Then:
- Tighten the sawblade (See the section on Setting up your saw).
- Adjust the sawblade (See the section on Upkeep and maintenance).
- Install the rack (See the section on Upkeep and maintenance).
- Run the saw for at least one minute as a test run.
- Unplug the saw, remove the power plug and check the entire set-up once again.
9.2 ADJUSTING THE SAWBLADE (Fig. 23)
If the sawblade is not positioned in the middle of the rubber tires, you have to adjust the tilt of the upper wheel:
1. Loosen the nut (46).
2. Tighten the set screw (47).
- Turn the set screw (47) clockwise if the sawblade is closer to the front of the saw.
- Turn the set screw (47) counter-clockwise if the sawblade is closer to the back of the saw.
3. Tighten the nut (46).
9.3 ADJUSTING THE UPPER SAWBLADE GUIDE (Fig. 24 - 25 - 26)
The upper sawblade guide consists of the following parts:
• A roller (which supports the sawblade from the back)
• Two lateral rollers (which guide the sawblade laterally)
These parts have to be adjusted each time you change or adjust the sawblade.
Useful tip:
• Check the lateral rollers regularly for wear and, when necessary, replace both rollers at the same time.
All manuals and user guides at all-guides.com
23
GB