EINHELL 43.309.20 Mode D'emploi D'origine page 16

Anleitung_RT_CS_190_L_SPK1:_
GB
6.4 Changing the saw blade (Fig. 10-13)
Important. Always pull out the power plug
before doing any work on the circular saw!
Only use saw blades of the same type as the saw
blade supplied with this circular saw. Ask your dealer
for advice.
Use the saw blade key (13) supplied to change the
saw blade. The saw blade key (13) is stored in the
soleplate (6). Pull the saw blade key (13) out of the
soleplate (6) when you need it.
Important. The hand-held circular saw must not be
operated with the saw blade key (13) inserted in it.
Press the spindle lock (11).
Undo the screw to secure the saw blade (17)
using the saw blade key (13).
Push back and secure the moving swing guard
hood (19) using the lever for the swing guard
hood (20).
Remove the flange (18) and the saw blade (12) in
a downwards direction.
Clean the flange and insert the new saw blade.
Pay attention to the running direction (see arrow
on the guard hood and saw blade).
Tighten the screw to secure the saw blade (17),
check it runs true.
Before you press the On/Off switch, make sure
that the saw blade is correctly fitted and that
moving parts run smoothly and the clamping
screws are tightened securely.
6.5 Using the laser and the LED light (Fig. 14-15)
The laser (24) enables you to make precision
cuts with your circular saw.
The laser light is generated by a laser diode. The
laser light is enlarged to form a line and is emitted
through the laser emission aperture. You can
then use the line as an optical marker for the
sawing line for precision cuts. Follow the laser
safety instructions.
The LED light (23) can be used in poor lighting
conditions to additionally illuminate the cutting
position.
Use the combination switch for the laser/LED light
(22) to switch the laser and the LED light and off.
After inserting the plug into the socket, you can
select the following combinations with the
ON/OFF switch for the laser/LED light.
Press once: Laser ON
Press twice: Laser OFF - LED light ON
Press three times: Laser ON - LED light ON
Press four times: Laser OFF - LED light ON
16
14.07.2009 10:54 Uhr Seite 16
The laser beam and the LED lamp can be
affected by deposits of dust and chips. The
emission aperture of the laser beam and the LED
light must therefore be cleaned after each use.
Always switch off the laser when not in use.
Always switch off the LED lamp when not in use.
The laser and LED light are powered by the
mains voltage. Batteries are therefore not
required.
7. Replacing the power cable
If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
8. Cleaning, maintenance and
ordering of spare parts
Always pull out the mains power plug before starting
any cleaning work.
8.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
8.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
8.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.