EINHELL 43.309.20 Mode D'emploi D'origine page 14

Anleitung_RT_CS_190_L_SPK1:_
GB
4. Technical data
Mains voltage:
Power input:
Idling speed:
Cutting depth at 90°:
Cutting depth at 45°:
Saw blade:
Blade holder:
Blade thickness:
Protection class:
Weight:
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Handle
Vibration emission value a h = 3.985 m/s
2
K uncertainty = 1.5 m/s
Additional handle
Vibration emission value a h ≤ 2.5 m/s
2
K uncertainty = 1.5 m/s
Important!
The vibration value changes according to the area of
application of the electric tool and may exceed the
specified value in exceptional circumstances.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
14
14.07.2009 10:54 Uhr Seite 14
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever
230 V ~ 50 Hz
necessary.
1500 W
Switch the appliance off when it is not in use.
Wear protective gloves.
-1
5,200 min
66 mm
5. Before starting the equipment
44 mm
Ø 190 mm
Before you connect the equipment to the mains
Ø 30 mm
supply make sure that the data on the rating plate are
2.4 mm
identical to the mains data.
II / ®
Always pull the power plug before making
adjustments to the equipment.
5.34 kg
5.1 Setting the cutting depth (Figure 2/3)
Release the handle on the rear of the guard hood
for adjusting the cutting depth (4).
Place the saw foot (6) flat on the surface of the
workpiece you wish to saw. Raise the saw until
the saw blade (12) is at the required cutting depth
(a).
Refasten the handle for adjusting the cutting
94 dB(A)
depth (4). Check the handle is securely fastened.
3 dB
108 dB(A)
5.2 Miter stop (Figure 4/5)
3 dB
The preset standard angle between the saw foot
(6) and saw blade (12) is 90°. You can adjust this
angle to carry out angled cuts.
Release the locking lever for miter setting (7) on
the front of the saw foot.
You can now adjust the cutting angle to around
45°. Keep an eye on the cutting angle scale (9) as
you do so.
Refasten the locking lever for miter setting (7).
2
Check the handle is securely fastened.
5.3 Extraction of dust and chips (Figure 6)
Connect a suitable vacuum cleaner (a) to the
provided chip extractor connector (14) of your
2
circular saw (vacuum cleaner not included). This
will provide excellent dust extraction on the
workpiece. The benefits are that you will protect
both the equipment and your own health. Your
work area will also be cleaner and safer.
Dust created when working may be dangerous.
Refer to the section entitled "Safety instructions".
Important! The vacuum cleaner you use for the
extraction work must be suitable for the
workpiece material.
Check that all the parts are properly connected.