Dräger Polytron 6100 EC WL Notice D'utilisation page 51

3. Put the magnetic pen back on the marking for 1 second (LED stops flashing)
and then take it off.
✓ The gas detector restarts and is reset.
13.3 Adjustable safety-relevant settings
PolySoft Factory setting
SIL status off
® off
Bluetooth -pairing PIN
Measured gas sensor-specific
Sample gas module sensor-specific
Measuring range sensor-specific
Upper capture value limit sensor-specific
Lower capture value limit sensor-specific
Test gas sensor-specific
Test gas unit sensor-specific
Test gas concentration sensor-specific
Calibration interval sensor-specific
A1 alarm sensor-specific
A2 alarm sensor-specific
Capture value sensor-specific
Measured gas LEL factor sensor-specific
watchdog timeout 60,000
®
PROFIsafe
1
®
PROFIsafe address
address 1
®
F device PROFIsafe
float
®
PROFIsafe data format
Instructions for use |
Dräger Polytron
®
6100 EC WL, Dräger Polytron
PolySoft Factory setting
Over the Air
™
ISA100 Wireless provision-
ing
Serial number of the gas detector
™
ISA100 Wireless Tag name
™ Network ID 0
ISA100 Wireless
SIL lock parameter password [Blank space] [Blank space] [Blank space] 2
SIL lock maintenance pass- [Blank space] [Blank space] [Blank space] 1
word
14 Transport
The gas detector contains lithium batteries. During transportation, especially
when transporting the gas detector by air, observe the relevant safety
regulations and marking for lithium batteries.
15 Disposal
This product must not be disposed of as municipal waste. It is therefore
marked with the adjacent symbol. Dräger will take back this product for
free. For information please contact the national marketing organiza-
tions or Dräger.
Batteries must not be disposed of as household waste. They are there-
fore marked with the adjacent symbol. Dispose of batteries and
rechargeable batteries at battery collection points and in accordance
with current regulations.
Disposal of electrochemical sensors
WARNING
Danger of explosions and risk of chemical burns!
Sensor fluids may leak out and can cause acid burns.
► Do not dispose sensors in fire.
► Do not open with force.
®
Repeater ISA100
| en
Transport
51