Keysight E36731A Manuel D'instructions page 93

Using the Sequencer Function
List mode
Continuous mode
Pulse mode
Toggle mode
There are four types of sequencer mode: List, Continuous*, Pulse*, and Toggle*.
Press Sequencer to select the sequencer type.
Press Back to return to Sequencer main menu.
* Applicable for Load mode only
List mode
List mode lets you generate complex sequences of output changes with rapid, precise timing, which may be
synchronized with internal or external signals. This is useful when running test sequences with a minimum amount of
programming overhead.
The Sequencer List allows single or multiple outputs to run in sequence. You can set the followings for each of the
output in sequence.
1. Set the step that will generate the trigger out signal at the beginning/end of the step.
2. Set the last output value after the sequence list completes.
3. Set how the list responds to triggers.
4. Set the transient mode for voltage and current.
5. Set the trigger source for the transient system.
6. Set the trigger delay in seconds.
7. Set the list repeat count.
8. Set the list to repeat continuously.
You can configure up to 512 steps in the Sequencer List window.
Keysight E36731A User's Guide 93