Sony HT-CT500 Mode D'emploi page 59

4
Set the Control for HDMI function of the
TV to on.
The Control for HDMI function for the
system and the connected component is
simultaneously set to on.
During the setting, "SCANNING" appears
in the front panel display. After you finish
the setting, "COMPLETE" appears in the
front panel display. Wait until the setting is
complete.
If "SCANNING" or "COMPLETE"
does not appear after performing
the steps above
Set the Control for HDMI function to on for the
system and the connected component
individually.
1
Press GUI MENU.
"GUI MENU" appears in the front panel
display of the subwoofer and the GUI menu
appears on the TV screen.
2
X/x
Press repeatedly to select
[Settings], then press
The settings menu appears.
3
X/x
Press repeatedly to select [HDMI],
then press .
The HDMI menu appears.
4
X/x
Press repeatedly to select [Control
for HDMI], then press
5
X/x
Press to select [ON], then press
.
The Control for HDMI is set to on.
6
Press GUI MENU.
The GUI menu turns off.
7
Set the Control for HDMI function of the
connected component to on.
For details, refer to the operating
instructions of the connected component.
8
Select the input of the system
connected to the component you want
to use the Control for HDMI function for
(BD, DVD, SAT/CATV), and repeat step
7.
If you add or reconnect the
component
Perform the steps in "Preparing for the
"BRAVIA" Sync" and "If "SCANNING" or
"COMPLETE" does not appear after performing
the steps above" again.
Notes
• While setting the Control for HDMI function for the
system, the System Audio Control function does not
work.
• If the Control for HDMI function for the connected
component cannot be set simultaneously by setting
"Control for HDMI" of the TV, set the Control for
HDMI function using the menu of the connected
component.
• For details on setting the TV and the connected
components, refer to their operating instructions.
Tip
• The default setting of the Control for HDMI function
of the system is [ON].
or c.
or c.
59
GB