Renfert SILENT powerCAM EC Guide De Démarrage page 20

Operation
Switching On
EN
The suction unit is switched on and off via the on / off switch (3).
After activation:
♦ The suction unit performs an automatic filter cleaning sequence
(for approx. 8 seconds, loud vibrating noise).
Then the unit returns to the last set operating mode.
Select Mode: CAM-mode / Continuous Operation
• CAM-mode (20):
The extraction unit is controlled by the signals provided by the CAM device.
• Continuous operation (22):
The extraction unit runs continuously.
⇒ Press the operating mode key (21).
♦ To change the operating mode.
The extraction unit is for use with dry dust only!
When connected to a CAM device with wet and dry function, ensure that no residual moisture
from the CAM device enters the extraction unit.
Check that the extraction unit is in full working order for every milling procedure:
► Display error (26) is off.
► Suction turbine operates correctly without producing any peculiar noise or odor.
Extraction force
⇒ Press the extraction force key (23).
♦ Switch to another level (only in continuous operation mode).
Setting the Parameter
On delivery, there are parameters set, which in most cases, make it possible to work with the suction unit
without problems. Only in individual cases, if this is not possible, the parameters can be changed.
The setting of various parameters and the execution of a self-diagnosis are carried out in the program-
ming mode.
Information on how to set the parameters and perform a self-diagnosis can be found in the operat-
ing instructions in the Internet or in Figs. D and E at the start of this manual.
The four displays show which parameter is set:
Display CAM-mode (20)
Display continual operation (22)
Display empty dust drawer (24)
Display error message (26)
Carry out self-diagnosis
Audible signal (Buzzer) on / off
Time interval for full display of the dust drawer
Adjust the after-run time of the suction turbine
- 4 -
3
20 21 22