Renfert SILENT powerCAM EC Guide De Démarrage page 17

Introduction
This Quick Start Guide contains instructions on the operation of the product
and relevant safety information.
Detailed information on the product can be found in the operating instructions
which are available for download on our website at www.renfert.com/p915.
Enter the following item number: 29390000.
Symbols
In the instructions for use and on the unit itself you will find these symbols with the
following meanings:
Danger
This indicates a direct risk of injury. Consult accompanying documents!
Electrical current
This indicates a risk of hazard due to an electrical current.
Attention
Disregarding this warning may result in damage to equipment.
Note
This provides the operator with useful information to improve and ease use.
The device complies with the requirements of the applicable EU directives.
This product complies with the relevant UK legislation.
See UKCA Declaration of Conformity in the Internet under www.renfert.com.
The device is subject to the EU directive 2002/96/EG (WEEE directive).
Other symbols are explained as they occur.
Safety
Intended Use
This extraction unit is intended for use with dental milling machines for the suction of dry dust, generated
whilst milling commercially available milling blocks and blanks.
The device is intended exclusively for commercial use.
The intended use also includes compliance with the instructions specified by the manufacturer concerning
operation, servicing and maintenance.
Improper Use
Fire-promoting, easily flammable, hot, burning or explosive materials must not be suctioned into the de-
vice. It is not permitted to suction liquids.
This device is not intended for private, household use.
Any use other than specified in these instructions is deemed improper and constitutes a misuse of the
device.
The manufacturer shall not be liable for damages caused by improper use.
Only spare parts and accessories supplied or authorized by Renfert GmbH may be used with this prod-
uct. If other spare parts or accessories are used, this could have a detrimental effect on the safety of the
device, increase the risk of serious injury and lead to damage to the environment or the device itself.
Hazard and Warning Information
General Information
► If the device is not used in compliance with the supplied instructions, the safety of the device can
no longer be guaranteed.
► The device may only be operated using a mains cable with the country-specific plug system. Any
necessary alterations must be carried out by a qualified electrician.
► The device may only be operated if the information on the identification plate conforms to the
specifications of your local mains power supply. After removing the Dust Drawer, you can find the
identification plate below, inside the device on the left side.
► The device may only be plugged into outlets which are connected to the protective conductor
system.
- 1 -
EN