JVC KD-AR7000 Manuel D'instructions page 34

To select the dimmer mode—Dimmer
When you turn on the car headlights, the
display and button illumination automatically
dims (Auto Dimmer).
• Auto: Activates Auto Dimmer.
• Off: Cancels Auto Dimmer.
• On: Always activates Dimmer.
To adjust the display brightness
—Bright
You can adjust the brightness to make the
display clear and legible.
To turn the tag display on or off
—ID3 Tag
An MP3 and WMA track can contain track
information called "Tag" where its album
name, performer, track title, etc. are recorded.
• On: Shows the Tag display while playing
MP3 or WMA tracks.
• Off: Cancels the Tag display. Only the
folder name and track name appear.
For MP3 tracks only: There are two versions–
ID3v1 (ID3 Tag version 1) and ID3v2 (ID3 Tag
version 2). When both ID3v1 and ID3v2 are
recorded, ID3v2 will be shown.
To change the FM tuner selectivity
—IF Filter
In some areas, adjacent stations may interfere
with each other. If this interference occurs,
noise may be heard.
• Auto: When this type of interference
occurs, this unit automatically
increases the tuner selectivity so that
interference noise will be reduced.
(But the stereo effect will also be
lost.)
• Wide: Subject to the interference from
adjacent stations, but sound quality
will not be degraded and the stereo
effect will not be lost.
34
To select the external component to use
—EXT Input
To use the external component connected to the
CD changer jack as the playback source
through this unit, you need to select which
component to use.
• Changer: To use a JVC CD changer.
• Line In: To use any external component
except the other two (selectable
only for KD-SHX700).
• Sirius: To use a JVC SIRIUS Radio.
To turn on/off the key-touch tone—Beep
You can deactivate the key-touch tone if you do
not want it to beep each time you press a
button.
• On: Activates the key-touch tone.
• Off: Deactivates the key-touch tone.
To select the amplifier gain control—
Amp Gain
You can change the maximum volume level of
this unit. When the maximum power of the
speakers is less than 50 W, select "Low Power"
to prevent them from being damaged.
• HighPower: You can adjust the volume level
from "0" to "50."
• Low Power:You can adjust the volume level
from "0" to "30."
• Off: Deactivates the built-in
amplifier. (Sounds come out
only from external amplifiers
connected to LINE OUT/
SUBWOOFER OUT plugs.)