Publicité
Les langues disponibles
Les langues disponibles
Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Caution! Disconnect the plug from the
mains socket.
1. Pull the left side of the lamp cover with your fingers
to unlock it. Remove the cover by pulling it towards
yourself.
Installation
Warning! Refer to Safety chapters.
Location
Refer to the assembly instructions for the
installation.
To ensure best performance, install the appliance well
away from sources of heat such as radiators, boilers,
direct sunlight etc. Make sure that air can circulate
freely around the back of the cabinet.
Positioning
Install the appliance in a dry, well ventilated indoors
where the ambient temperature corresponds to the
climate class indicated on the rating plate of the
appliance.
Climate
Ambient temperature
class
SN
+10°C to + 32°C
N
+16°C to + 32°C
ST
+16°C to + 38°C
All manuals and user guides at all-guides.com
1
2
1
2. Replace the bulb with one of the same power and
shape, specifically designed for household
appliances. (the maximum power is shown on the
light bulb cover).
3. Install the lamp cover.
4. Connect the plug to the mains socket.
5. Open the door.
Make sure that the light switches on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to assembly
instructions.
3. If necessary, replace the defective door gaskets.
Contact the Authorised Service Centre.
Climate
Ambient temperature
class
T
+16°C to + 43°C
Some functional problems might occur
for some types of models when
operating outside of that range. The
correct operation can only be guaranteed
within the specified temperature range. If
you have any doubts regarding where to
install the appliance, please turn to the
vendor, to our customer service or to the
nearest Authorised Service Centre.
Electrical connection
•
Before plugging in, ensure that the voltage and
frequency shown on the rating plate correspond to
your domestic power supply.
•
The appliance must be earthed. The power supply
cable plug is provided with a contact for this
purpose. If the domestic power supply socket is not
earthed, connect the appliance to a separate earth
in compliance with current regulations, consulting a
qualified electrician.
•
The manufacturer declines all responsibility if the
above safety precautions are not observed.
•
This appliance complies with the E.E.C. Directives.
9
Publicité
