GE 22 Série Manuel D'utilisation Et D'installation page 7

Slide-Out Spillproof Shelf
The slide-out spillproof shelf allows you
to reach items stored behind others. The
special edges are designed to help prevent
spills from dripping to lower shelves.
To remove:
Remove all items from shelf.
Slide the shelf out until it stops.
Lift the front edge of the shelf until the
central tabs are above the front bar.
Continue pulling the shelf forward
until it can be removed.
Adjustable Bins on the Door
Finger hold
Snugger
Adjustable bins can easily be carried from
refrigerator to work area.
To remove: Lift bin straight up, then
pull out.
To replace or relocate: Engage the bin in the
molded supports of the door, and push in.
Bin will lock in place.
Non-Adjustable Shelves on the Door
To remove: Lift the shelf straight up, then
pull out.
To replace: Engage the shelf in the molded
supports on the door and push down.
It will lock in place.
Freezer Tilt Out Bin
Push the button as you tilt out the bin.
To remove: Hold the sides of the bin and
lift it straight up, then pull out.
To replace: Engage the ends of the bin in
the molded supports on the door and
push down. It will lock in place.
NOTE: Do not overload the bin.
(on some models)
To replace:
Make sure that the shelf sits flat after reinstallation
and doesn't move freely from side to side.
Make sure you push the shelves all the way in
before you close the door.
The snugger helps prevent tipping, spilling
or sliding of small items stored on the door
shelf. Grip the finger hold near the rear of
the snugger and move it to fit your needs.
(on some models)
www.GEAppliances.com
Place the rear shelf tabs just in front of
the central notches on the shelf frame.
Slide the shelf in until the central tabs
are slightly behind the front bar.
Lower the shelf into place until it is
horizontal and slide the shelf in.
7