Publicité
Les langues disponibles
Les langues disponibles
Dustbane Integra Scrub - Surface Preparation Machines
About the Integra Scrub Floor Machine.
Our Integra Scrub offer removable weights, a minimum 1.5hp, 1725rpm motor, powder coated 10 gauge steel, heavy duty frame,
and 6"x2" non-marking ball-bearing wheels with a heavy duty ¾" solid steel axle. Removable weights not only make our machine
easy to transport but allow users to tailor the weight to suit their project needs.
With a selection of different surface preparation pads, there really is only one machine for the job. The Dustbane Integra Scrub are
designed to make the most efficient use of every pad, paper or screen used with the machine, saving both time and MONEY.
Please visit our web site at
www.dustbane.ca
Introduction
You are now the proud owner of an Integra Scrub machine. This machine is a product of Dustbane.It is made of fine materials and
will give you many years of satisfactory service if maintained and used according to the guidelines in this owner's manual. Please
read all Installation, Operation, and Safety Instructions before using this machine.
This product is for Industrial/Institutional/Commercial Use Only.
WARNING: Potential risk of injury!
This product contains moving parts. To reduce the risk of injury, unplug before servicing.
General Safety
•This floor-finishing machine shall be grounded while in use to protect the operator from electric shock.
The machine is provided with a threeconductor cord and a three-contact grounding type attachment
plug to fit the proper grounding type receptacle. The green (or green and yellow) conductor in the cord is
the grounding wire. Never connect this wire to anything other than the grounding pin of the attachment
plug.
• This machine is for use on a nominal 120-volt circuit and has a grounding plug that resembles the plug
in figure 1. Make sure that the machine is connected to an outlet having the same configuration as the
plug. No adapter should be used with this machine.
Maintenance Schedule
Prior to using (daily)
• Check AC power cord. Do NOT operate equipment if AC power cord is cut, frayed or if ground is missing.
• Check vacuum hose and connections (if equipped).
• Check grip face and driver pad: inspect for wear/debris. Replace as needed.
After use (daily)
• Clean pad and base plate assembly : remove/replace pad as needed.
• Inspect grip face for wear. Remove debris between grip face and baseplate.
• Wipe base plate and motor assembly with damp microfiber cloth.
• Make certain a pad is placed on grip face.
Weekly PM
• Check grip face for wear.
• Use vacuum to clean away debris build-up around motor assembly, weights and base plate.
All manuals and user guides at all-guides.com
3 3
Publicité
