Getting Started; Unpacking; Hooking Up The System - Sony TC-KE600S Mode D'emploi

Getting Started

Unpacking

Check that you have received the following supplied
item:
• Audio connecting cords (2)

Hooking Up the System

This section describes how to hook up the tape deck to
an amplifier. Be sure to turn off the power of each
component before making the connections.
to LINE IN
to LINE OUT
to REC OUT
Hookups
When connecting an audio connecting cord, be sure to
match the color-coded cord to the appropriate jacks on
the components: Red (right) to Red and White (left) to
White. Be sure to make connections firmly to avoid
hum and noise.
Connect the tape deck to the amplifier as shown
below.
Tape deck
Ç
LINE
IN OUT
L
R
:Signal flow
ç
4 EN
TC-KE600S
/
to an AC
(socket) outlet
to TAPE IN
Amplifier
/
to a
wall outlet
(mains)
Amplifier
TAPE
REC OUT IN
L L
R R
ç
To connect your tape deck to another tape deck
Connect both tape decks as shown below.
Tape deck Another tape deck
LINE
IN OUT
L
ç L
R
R
Ç
ç :Signal flow
Setting the voltage selector (only on
models supplied with a voltage selector)
Check that the voltage selector on the rear panel of the
tape deck is set to the local power line voltage. If not,
set the selector to the correct position using a
screwdriver before connecting the AC power cord to
an AC outlet.
VOLTAGE
220V
240V
120V
Connecting the AC power cord
Connect the AC power cord to an AC outlet.
Where do I go next?
Now you're ready to use your tape deck.
For basic operations, go to pages 5 to 7; for advanced
operations, go to the sections starting from page 8.
LINE
IN OUT
L
R
3-856-296-51(1)