Starting And Stopping; Check Before Starting - Husqvarna 535FBX Manuel D'utilisation

Check before starting

• Check the cutting attachment. Never use blunt,
cracked or damaged equipment.
• Check that the machine is in perfect working order.
Check that all nuts and screws are tight.
• Make sure the chain is sufficiently tensioned. See
instructions under the heading Tensioning the chain.
• Make sure the chain is adequately lubricated. See
instructions under the heading Lubricating the cutting
attachment.
• Make sure that the handle and safety features are in
good working order. Never use a machine that lacks a
part or has been modified outside its specifications.
70 – English

STARTING AND STOPPING

Starting and stopping
WARNING! The complete clutch cover
!
and shaft must be fitted before the
machine is started, otherwise the clutch
can come loose and cause personal
injury.
Always move the machine away from the
refueling area and source before
starting.
Place the machine on a flat surface.
Ensure the cutting attachment cannot
come into contact with any object. Make
sure no unauthorised persons are in the
working area, otherwise there is a risk of
serious personal injury. The safety
distance is 15 meters (50 ft.).
Starting
Primer bulb: Press the air purge repeatedly until fuel
begins to fill the bulb. The bulb need not be completely
filled.
Choke: Set the choke control in the choke position.
WARNING! When the engine is started
!
with the choke in choke position the
cutting attachment will start to rotate
immediately.
Hold the body of the machine on the ground using your
left hand (CAUTION! Not with your foot!). This is important
to avoid damaging the machine's vibration damping