Gear - Husqvarna 535FBX Manuel D'utilisation

Oiling the air filter
Always use HUSQVARNA filter oil, art. no. 531 00 92-48.
The filter oil contains a solvent to make it spread evenly
through the filter. You should therefore avoid skin contact.
Put the filter in a plastic bag and pour the filter oil over it.
Knead the plastic bag to distribute the oil. Squeeze the
excess oil out of the filter inside the plastic bag and pour
off the excess before fitting the filter to the machine. Never
use common engine oil. This would drain through the filter
quite quickly and collect in the bottom.
IMPORTANT! Use only HUSQVARNA replacement
parts. Use of other brands of replacement parts can
cause damage to your unit or injury to the operator or
others. Your warranty does not cover damage or liability
caused by the use of accessories and/or attachments
not specifically recommended by HUSQVARNA.
MAINTENANCE

Gear

Check that there is grease in the gear housing, and fill
with new grease if necessary. This should be done
approximately every 6 months. Do as follows:
1 Loosen the two screws (A) and (B), and remove the
cutting head from the shaft.
2 Check that there is grease in the gear housing by
looking in the hole for the drive shaft (se picture). If no
grease can be seen, the gear housing should be filled
with new grease.
3 Fill with grease by putting the tube of grease as far into
the hole as possible, and fill until grease starts to
trickle out of the hole.
4 Fit the cutting head on the shaft and tighten the two
screws.
B
A
English
–
79