Starting And Stopping; Before Starting; Starting; Stopping - Husqvarna WS 460 Manuel D'utilisation

Before starting

• Enclose the area to be cut so that unauthorised persons
can not be injured or disturb the operator.
• Check that the blade and th blade guard is not damaged
or cracked. Replace the blade or the blade guard if it is
exposed to impact or is cracked.
• Make sure that all hydraulic hoses and connections are
intact and correctly connected, and that the water cooling
is correctly connected and switched on.
• Check the oil level in the cutting unit. Adjust the speed
valve on the saw motor to the correct position, depending
on the blade diameter. (See the Cutting capacity table).
• If cutting is to begin in another position than where the saw
unit is located, run the saw unit to the start position.

Starting

1 Turn on the hydraulic unit.
2 Start the blade rotation by pushing the lever for starting/
stopping the blade rotation in towards the block and then
carefully pull the lever up towards the hose connector.
3 The blade is manually moved to the required depth.

STARTING AND STOPPING

4 Start the travel feed. Turn the handle on the directional
control valve for travel feed, so that the saw moves in the
required direction.
If the blade meets resistance during the cutting, a valve
stops the travel feed automatically. The travel feed starts
automatically again when the resistance decreases and
the pressure returns to the normal.
5 The speed of the travel feed is controlled with the valve for
adjustment of travel feed force. Adjust the valve to the
desired position.
If the travel feed "jerks", the cause may be too high feed,
which releases the valve for travel feed control and the
travel feed stops. Lower the travel feed force until the feed
is even.

Stopping

1 Once cutting is completed, remove the blade from the wall
and shut down the blade rotation and the water flow.
2 Shut down the hydraulic unit.

Dismantling the saw

1 Allow the motor to stop completely.
2 Switch off the power to the hydraulic unit.
3 Disconnect the hydraulic hoses and the water hose from
the saw unit.
The other steps are done in the reverse order to assembling.

Cleaning

The saw should be cleaned once cutting is finished. It is
important to clean all the saw equipment. The saw is best
cleaned with the supplied cleaning brush by connecting it to
the water hose.
IMPORTANT! Do not use a high pressure washer to clean
the saw.
– 13
English