Oase InScenio EGC Notice D'emploi page 42

- EN -
The symbols used may differ slightly from the symbols on your smartphone/tablet.
iOS Android
6.3 Operating status display
 H
The LED on the device indicates the operating status of the InScenio EGC Controller.
LED co- LED status
lour
– Off
Green Lit
Flashing fast
Flashing slowly (2 seconds on,
1 second off)
Yellow Lit
Flashing fast
Flashing slowly (2 seconds on,
1 second off)
Red Flashing
42
How to proceed:
1. Open "Settings".
2. Select and activate WLAN.
3. Select ʺOase EGC Controller xxxxxxʺ from the network list.
4. Enter the WiFi password and select "Connect".
The connection to the InScenio EGC Controller is established.
If the connection is successful, "Connected" (Android) or a "" (iOS) will appear un-
der the network name.
Other WLAN connections are deactivated.
5. Start the "OASE Easy Control" app.
The app automatically selects the language used by the operating system. If the app
does not support that language, it will use English.
When establishing the connection to the InScenio EGC Controller for the first time, it
is necessary to define a device password to protect the InScenio EGC Controller
from unauthorised access.
Remember the device password as it is also required for adding the InScenio EGC
Controller Cloud to the OASE cloud. (→ Activating the cloud connection)
Description
InScenio EGC Controller is switched off.
InScenio EGC Controller is ready for operation and in access point mode.
WPS is activated, InScenio EGC Controller is waiting for the router access data.
InScenio EGC Controller is ready for operation and connected to the router.
InScenio EGC Controller is starting up or is in update mode.
Firmware update in progress
InScenio EGC Controller is searching for a connection to the router.
Malfunction
Remedy:
Disconnect from the power supply. Wait for 10 seconds then reconnect.
Reset the InScenio EGC Controller to the factory default settings (→ Restoring the fac-
tory default settings)
Carry out a firmware update (→ Updating the firmware)