Renfert Dustex master plus Mode D'emploi page 17

4 Installation / Commissioning
Prior to connecting the unit to the mains power supply, compare the information on the extraction
box nameplate with the specifications of the local mains power network.
4.1 Setting Up the Unit and Connecting it to an Extractor
Connect the extraction hose to the extraction tube (Figure 1)�
4.2 Commissioning
1� Connect one end of the power cord to the extraction box (Figure 2) and plug the other end into the wall
outlet (Figure 3)�
2� Switch the unit on (Figure 4)�
If the membrane key is damaged or defect, please disconnect the device and send away for repair!
If the membrane is removed there is the risk of an electrical shock!
Your extraction box is now ready for use.
4.3 Reversing the View Pane
The view pane has a plastic coating on one side�
The eye protection symbol provides you with an indication as to which side of the pane faces inwards:
on the left >>>
on the right >>>
This coating is particularly resistant to the abrasive particles and dust generated during grinding�
However, when grinding and milling components containing acrylics, electrostatic charges may cause
dust and particles to adhere to the coating�
Polishing agents containing solvents may also damage the coating.
In such cases, the viewing pane can be reversed so that the uncoated side faces inwards.
The following steps are required in order to do this:
1� Loosen the screws (Figure 7)�
2� Pull the pane out (Figure 8)�
3� Reverse the pane�
4� Reinsert the pane (Figure 8)�
5� Retighten the screws (Figure 7)�
4.4 Armrests (Figure 9)
Armrests can be installed on the Dustex master plus to help relieve strain during work with the unit�
The instruction sheet is attached to the Set of armrests�
4.5 Magnifier (Figure 10)
A magnifier attached to a flexible arm can also be installed on the extraction box (please refer to the ac-
cessories list)�
Installation instructions are provided with the magnifier.
Coated side inwards (Figure 5)
Glass side inwards (Figure 6)
- 5 -
EN