Hitachi P-AP56NAM Manuel D'installation Et De Fonctionnement page 12

AIR PANEL P-AP56NAM
7 AIR PANEL P-AP56NAM
7.1 NAME OF PARTS
Air panel
P-AP56NAM
7.2 INSTALLATION
!
C A U T I O N
Pay attention to perform the installation work at high-place using a
stepladder, etc.
?
N O T E
• Do not move the louver by hand.
• If moved, the louver mechanism will be damaged.
• In addition, do not apply an excessive force to the air outlet part to
prevent the breakage.
1 The suspension height of the indoor unit should be referred
to "Installation & Maintenance Manual" of the indoor unit.
2 Do not touch the louver during the installation work.
3 Remove the air inlet grille from the air panel.
While pushing both ends of knobs at the air inlet grille
toward the arrow direction, open the air inlet grille until the
angle of approximately 45° from the air panel surface. After
lifting the air inlet grille keeping it inclined, draw the air inlet
grille forward.
(Remove the filament tape (4 portions) fixing the air filter.)
4 PMML0570 rev.0 - 01/2021
Air inlet grille
Corner pocket
cover (4 portions)
?
N O T E
Although the air inlet grille can be opened until the angle of 90° from the
air panel surface, it can not be removed from the air panel.
Louver
Air outlet
Air inlet grille
Air panel
Knob