Assembly - LawnMaster VBRM16 Manuel D'instructions

ASSEMBLY

Preparation
■ The lawnmower is supplied fully assembled.
■ Carefully remove all contents from the product packaging.
■ The battery is supplied in a partially charged state. Place the battery on the supplied charger
and allow the battery to fully charge before first use.
Prepare the Mowing Area (See Figs. 1-2)
Lawn Surface
■ The lawn surface should be as uniform as possible. Bare patches and leaves can disrupt the
operation of the mower. Clear leaves at regular intervals and repair dead patches with grass
seed.
■ Inspect the lawn for holes or hollows. Fill them with topsoil to prevent rainwater from forming
pools of water on the lawn and to prevent mower from becoming stuck. The mower may be
damaged if it is operated in pools of water (Fig. 1).
■ If there are stones on the lawn that may damage the mower, they should be removed or
excluded from the working area (Fig. 2).
NOTE: This mower is not designed to cut excessively long or overgrown and neglected areas.
For best performance mow or trim grass down to 60mm before use. Do not allow grass to grow
excessively long between uses.
Define the Mowing Area (See Figs. 3-12)
Lawn edges must be clearly defined by flat edging or raised barriers in order for this mower to
function properly.
■ Visual boundaries need to look different from grass, therefore changes in colour and texture are
very effective.
■ Physical boundaries help stop the mower when a visual boundary is not possible.
■ Temporary physical boundaries can be used while the lawn boundary definition is improved.
The robotic mower is equipped with the following devices which allow it to detect the edges and
know where to mow:
- The grass detection camera: for recognizing changes in surface type, e.g., from grass to
paving.
- Two ultrasonic object sensors: for detecting the obstacles higher than 6 cm. They are turned
on by default setting and will sense plants, shrubs and other obstacles in and around the edges
of the lawn. For a consistent cut, long grass must be cut down before mowing, or the ultrasonic
sensors must be turned off.
The ultrasonic sensors can be turned off when the lawn to be mowed is clear of obstacles. In this
case, hedges, walls, or other similar barriers in the lawn can be used as the border of the working
area.
17