Install The Keypad - Kohler K-1000-H2 Instructions D'installation

28. Install the Keypad

Mark the hole location for the keypad between 58" (147.3cm) and 60" (152.4cm) above the footbath
basin. If the keypad will be installed to tile, center the mark on a tile.
Refer to the illustration above. Drill a 3/16" (5mm) diameter hole at the top center as shown. Use a
1-5/8" carbide hole saw to carefully cut the larger hole through the finished wall material, cement
board and waterproofing material.
Slip the gasket onto the housing. Apply a generous, continuous bead of clear, high-quality silicone
sealant to the back of the keypad housing and the gasket. Insert the housing into the hole and
loosely thread the plastic nut to the housing from the back.
Check to be sure the keypad is properly aligned. Securely tighten the plastic nut from behind.
NOTE: The outer ring on the keypad must rotate freely.
Remove any excess sealant.
Locate the wire harness connection labeled "keypad". Align and press this connection into the back
of the keypad. Connect the other end to the control by aligning and pressing into place.
Locate and remove the remote control, which is secured to the harness near the suction line.
Store the remote control safely for future use.
Kohler Co.
Control
Housing
Gasket
Install switch 58" (147.3cm)
to 60" (152.4cm) above
footbath basin
HOLE PATTERN
Nut
Wire Harness
3/8" D. (1cm)
(Drill First)
1-5/8" D. (4.1cm)
(Drill Second)
23 1032118-2-A