Install The Center Expanders - Kohler K-1000-H2 Instructions D'installation

12. Install the Center Expanders

Remove and discard the thread caps from the center expanders.
Fit a center expander into one of the wall jambs. The projection on the center expander fits behind
the footbath locating pin.
Push the bottom of the center expander all the way into the wall jamb. Plumb the center expander
by turning the top buttonhead screw in or out with the balldriver tool.
Check for plumb with a level.
When the center expander is plumb, turn in the center buttonhead screw until you feel it just
contact the wall jamb.
Recheck for plumb, then secure the center expander to the wall jamb with three 3-1/2" stainless
steel flathead screws (provided).
Remove the protective tape from the inside of the wall jamb.
Do not remove the tape from the outside of the wall jamb at this time.
Repeat for the other center expander.
1032118-2-A
Wall Jamb
Center
Expander
TOP VIEW
3-1/2" Stainless
Steel Flathead
Screw
Footbath
Locating Pin
Top
Buttonhead
Screw
Wall Jamb
12 Kohler Co.