Install The Handle - Kohler K-6228 Guide D'installation Et D'entretien

Retaining Ring
Valve Stem
Sliding Disk

7. Install the Handle

Apply plumbers putty or other suitable sealant to the back of the
escutcheon.
Thread the escutcheon tight against the finished wall.
Slide the following components onto the valve stem: bearing,
sliding disk, friction cup, ball joint, and spring.
Hold the components in place on the valve stem, then thread the
handle onto the valve stem until fully seated.
Unthread the handle until the setscrew hole is pointed at the 6
o'clock position.
Use a 5/64" hex wrench to fully tighten the setscrew into the
handle.
Turn on the water supply.
Check for leaks.
Kohler Co.
All manuals and user guides at all-guides.com
Apply sealant to the
back of the escutcheon.
Bearing
Friction Cup
Spring
Ball Joint
Setscrew
11
Handle
1095311-2-J