Adjust Header Height - Kohler K-1000-H2 Instructions D'installation

Header

17. Adjust Header Height

Slide all three door panels to the center. Measure and record the distance from the footbath curb to
the header at three locations: the left corner, along the wall jamb; the right corner, along the wall
jamb; and the center, along the center door panel.
If the three measurements are the same, no header adjustment is needed. If the center height is
different from the corner measurements, adjust the header as described below.
Loosen one of the buttonhead screws approximately two complete turns. Loosen the adjustment
screw a complete turn or two and retighten the buttonhead screw. Check the center height. Repeat
this procedure until 1/2 the needed height correction is obtained.
Repeat this adjustment procedure on the other end of the header.
NOTE: The center height measurement must be the same as the corner measurements when the doors are
in the center.
1032118-2-A
Buttonhead Screw
Adjustment Screw
Center Jamb
#8 x 1" Panhead
Screws
16
Header Bracket
Center
Support
Center Jamb
TOP VIEW
Kohler Co.