Philips AquaTrio 9000 Serie Mode D'emploi page 6

English
8
Assembling the Vacuum & Mop set-up
If you want to store and charge the Vacuum only set-up on the wall mount,
fasten the wall mount to the wall with the screws supplied. Make sure the wall
mount is 140 - 150 cm above the floor.
Note: It is not possible to store the Vacuum & Mop set-up on the wall-mount.
It is only possible to store the Vacuum only set-up on the wall mount.
Note: Make sure that the temperature in the room where the appliance is
stored or charged is between 5 °C and 35 °C.
Caution: Be careful when you drill holes in the wall to fasten the wall
mount, to avoid the risk of electric shock.
1 To assemble the Vacuum & Mop set-up, insert the battery and attach the
3-in-1 handheld to the wet module ('click').
2 Attach the wet module to the AquaSpin nozzle ('click').
3 To store the Vacuum & Mop set-up, you can place it in the After-Clean &
Storage station.
Note: It is not possible to store the Vacuum & Mop set-up on the wall-mount.
It is only possible to store the Vacuum only set-up on the wall mount.