Philips AquaTrio 9000 Serie Mode D'emploi page 42

English
44
Problem
There is no water on the
floor.
There is more water on the
floor or in the After-Clean
tray than usual.
The appliance leaves water
traces on the floor.
Possible cause
The clean water tank is empty.
The wetting strips are blocked.
The water channel of the wet
module and/or AquaSpin
nozzle is polluted or blocked.
The dirty water tank is not
placed correctly.
You have moved the appliance
sideways.
You made strong turns with
the appliance.
You have lifted the appliance
over a threshold, carpet or
Solution
wetting strips of the AquaSpin nozzle'). If
that does not help, you can try to carefully
open the holes with a needle.
Refill the clean water tank (see 'Using the
Vacuum & Mop set-up').
Remove the two microfiber brushes, fill the
clean water tank with some water, and
switch the appliance on. Make small
forward and backward movements on the
same position for around 15 seconds. You
should be able to see four water stripes on
the floor. If this is not the case, or if one or
more water stripes only consist out of a few
droplets, the wetting strips are partially or
fully blocked and you can rinse them under
the tap (see 'Clearing blockages from the
wetting strips of the AquaSpin nozzle'). If
that does not help, you can try to carefully
open the holes with a needle.
If you have checked the above and there is
still no water on the floor, take the
appliance to a Philips service center or
contact the Consumer Care Center.
Use the cleaning brush and clean the water
channel of the wet module and/or
AquaSpin nozzle (see 'Removing blockages
from the Vacuum & Mop set-up').
Place the dirty water tank into the
appliance properly (see 'AUTOCLEAN after
every use'). It is closed correctly when you
can hear a 'click' sound.
To prevent water traces on the floor, try to
make less strong turns with your AquaTrio
9000 Series and avoid moving the
appliance sideways. You can activate the
water absorption mode
cleaning mode button. All the remaining
water on your floor will be absorbed.
To prevent water traces on the floor, try to
make less strong turns with your AquaTrio
9000 Series and avoid moving the
appliance sideways. You can activate the
water absorption mode
cleaning mode button. All the remaining
water on your floor will be absorbed.
Make sure the microfiber brushes stay in
contact with the floor. Make sure water
by pressing the
by pressing the