Philips AquaTrio 9000 Serie Mode D'emploi page 26

English
28
Removing blockages from the Vacuum & Mop set-up
Clearing blockages from the wet module
Clearing blockages from the AquaSpin nozzle
Clearing blockages from the wetting strips of the AquaSpin
nozzle
Tip: You can also use a pair of scissors to cut hairs and threads that have
become entangled around the microfiber brushes.
The Vacuum & Mop set-up may become clogged. You may notice this when
more water gets on the floor than usual or when bigger dirt particles are no
longer sucked up and fall back on the floor. Below you can find the instructions
to remove blockages from different parts of the Vacuum & Mop set-up.
If there is a blockage in the wet module, first switch off the appliance and
remove the AquaSpin nozzle and the 3-in-1 handheld. Then remove the
blockage by moving the cleaning brush in the suction channel of the wet
module up and down.
If there is a blockage in the AquaSpin nozzle, it can be removed by moving the
cleaning brush up and down in the suction channel of the AquaSpin nozzle.
After long and frequent use of the appliance, the wetting strips of the AquaSpin
nozzle may become clogged at some point. Follow the steps below to clear the
blockage of the wetting strips of the AquaSpin nozzle.