Philips AquaTrio 9000 Serie Mode D'emploi page 46

English
48
Problem
When I use my vacuum
cleaner I sometimes feel
static electricity shocks.
Using the Vacuum only set-up
Problem
The appliance does not work
when I push the on/off
button.
It is not possible, to connect
the 3-in-1 Handheld to the
dust bucket.
Possible cause
Your vacuum cleaner builds up
static electricity. The lower the
air humidity, the more static
electricity the appliance builds
up.
You vacuumed up dust and
dirt. This also causes static
electricity.
Possible cause
You did not connect the
battery.
The battery is empty.
You pushed the on/off
button more than one time.
You did not connect the 3-in-1
Handheld to the appliance
correctly.
The appliance is clogged.
The roller brush is stuck.
The filter case is assembled
upside down.
The filter case is not closed
properly.
Solution
If you have checked the above and the
appliance still does not charge, take it to a
Philips service center or contact the
Consumer Care Center.
Make sure to touch the metal pin with your
hand while holding the appliance.
Make sure to touch the metal pin with your
hand while holding the appliance.
Solution
Connect the battery to the 3-in-1
Handheld.
To charge the battery, connect the 3-in-1
Handheld with the charger (see 'Charging').
Wait a few seconds and push the on/off
button again one more time.
Connect the 3-in-1 handheld correctly to
the dust bucket.
Switch the appliance off and remove the
battery or powerhouse. Then locate and
remove the cause for the blockage. After
that, restart the appliance. If you cannot
identify the cause of the blockage, restart
the appliance. This might already solve the
problem.
Take the roller brush out and remove any
hair around the brush and the motor and
place it back (see 'Cleaning the roller
brush').
Invert the filter case. The round opening
should be visible (see 'Cleaning the dust
bucket ').
Make sure you hear a click when closing
the filter case. If it is difficult to close, the
foam filter is probably placed upside down.