Philips AquaTrio 9000 Serie Mode D'emploi page 44

English
46
Problem
Bigger dirt particles are not
sucked up anymore and fall
back on the floor.
The floor dries with stripes.
There is too much foam
while cleaning, but also
during AUTOCLEAN.
It is difficult to clean stains.
The sound of the appliance
changed while cleaning.
The display indicates that the
dirty water tank is full (code:
i1) and shuts down,
although the dirty water
tank is not full yet.
Water drips out of the
appliance after it is switched
off.
Possible cause
The water channel of the wet
module and/or AquaSpin
nozzle is polluted or blocked.
You may have used too much
detergent.
The wheels are dirty.
You may have used too much
detergent.
There are still detergent
residues on the floor.
You may have used too little
water or taken too little time to
clean the stain.
There might be hairs or other
obstacles entangled around
the microfiber brushes
There may be foam or
contamination of the dirty
water tank.
The appliance leaves a puddle
on the floor because you did
not move it while switching it
off. This is normal.
The appliance is dripping when
carrying it over the floor
(holding it in the air).
Water leaks from the clean
water tank because you
overfilled the clean water tank.
Solution
Use the cleaning brush and clean the water
channel of the wet module and/or
AquaSpin nozzle (see 'Removing blockages
from the Vacuum & Mop set-up').
Make sure to use the right amount of
detergent (see 'Using the Vacuum & Mop
set-up').
Remove the dirt from the wheels.
Make sure to use the right amount of
detergent (see 'Using the Vacuum & Mop
set-up').
Clean the floor without detergent several
times. Wait a moment before going over
the same stain again.
Apply water and wait a moment. For
example you can go with the appliance
over the stain to apply water and come
back to the same stain in the end of the
cleaning session.
Remove the microfiber brushes and check
for obstacles and remove them (see
'Cleaning the AquaSpin nozzle').
Restart the appliance. If that does not solve
the problem, clean the dirty water tank. If
foaming is the issue, make sure you do not
use more than the recommended amount
of detergent (see 'Using the Vacuum &
Mop set-up').
The appliance can leave a small puddle of
water on the floor if you do not move the
appliance while switching it off. You can
reduce the size of the puddle by moving
the appliance while switching it off. When
you switch off the appliance, it will switch
to water absorption mode
to clean up any water remaining in the
nozzle. If needed, you can remove the last
drops with a cloth.
While cleaning, do not lift the AquaSpin
nozzle from the floor, as this leaves water
traces. Only move forwards and backwards.
Do not fill the clean water tank beyond the
MAX indication. If you do, water may spill
from the clean water tank when you fasten
the cap (see 'Using the Vacuum & Mop set-
up').
for 4 seconds