Philips AquaTrio 9000 Serie Mode D'emploi page 48

English
50
Problem
Dust escapes when opening
the dust bucket.
The filter cleaning icon is
shown on the display and
the device shuts down.
The appliance does not
move smoothly across the
floor when I am cleaning a
carpet.
The roller brush does not
turn anymore.
The LEDs in the nozzle do
not turn on.
The appliance is not
charging.
The Mini Turbo brush does
not function properly.
Possible cause
This is normal behavior due to
underpressure.
The filter may be dirty.
You selected a too high suction
power.
The roller brush is clogged with
hair or dirt.
The roller brush may stop
turning when it encounters too
much resistance from high-pile
carpet.
You have not assembled the
roller brush into the nozzle
properly after cleaning.
You have not attached the
nozzle to the tube or appliance
properly.
The plug is not connected
properly to the socket-outlet or
the adapter is not inserted into
the wall socket properly.
The battery is not in.
The battery is not completely
inserted.
Wrong adapter connected.
The roller brush is blocked.
The roller brush is blocked by
fabric or surfaces during
cleaning.
Solution
If possible, open the appliance outside.
We advise you to clean the filter. If you
cleaned the filter recently, you can
disregard this icon. To continue vacuuming,
click the arrow icon.
Reduce the suction power by choosing
setting 1 or move more slowly over the
carpet.
Clean the roller brush with a pair of scissors
or by hand (see 'Cleaning the roller brush').
Switch off the appliance and then switch it
back on again.
Follow the instructions in this user manual
to slide the roller brush into the nozzle
properly (see 'Cleaning the roller brush').
Secure the roller brush inside the nozzle by
snapping the locking lever in place.
Attach the nozzle to the tube or appliance
properly. If this does not help, please take it
to a Philips service center or contact the
Consumer Care Center.
Make sure that the plug is connected
properly to the socket-outlet and that the
adapter is inserted into the wall socket
properly.
Please insert the battery.
Please insert the battery until you hear a
click sound.
Please use the original adapter.
If you have checked the above and the
appliance still does not charge, take it to a
Philips service center or contact the
Consumer Care Center.
Remove hairs from the brush with a pair of
scissors (see 'Cleaning the Mini Turbo
brush').
Keep the mini Turbo brush aligned with the
surface and do not push the Turbo brush
into soft surfaces.