Philips AquaTrio 9000 Serie Mode D'emploi page 49

Problem
When I use my vacuum
cleaner I sometimes feel
static electricity shocks.
Error code 'E2' appears on
the display.
Error code 'E3' appears on
the display.
Possible cause
The roller brush is not properly
inserted into the nozzle.
Your vacuum cleaner builds up
static electricity. The lower the
air humidity, the more static
electricity the appliance builds
up.
You vacuumed up dust and
dirt. This also causes static
electricity.
The temperature is too low.
The temperature is too high.
Solution
Make sure the the roller brush is properly
inserted into the nozzle and that there is no
gap between the parts (see 'Cleaning the
Mini Turbo brush').
Make sure to touch the metal pin with your
hand while holding the appliance.
Make sure to touch the metal pin with your
hand, while holding the appliance.
Make sure the temperature in the room
where the appliance is used, stored, or
charged is above 5 °C.
Make sure the temperature in the room
where the appliance is used, stored, or
charged is below 35 °C. Do not expose the
device to direct sunlight or high
temperatures (near hot stoves, in
microwave ovens, or on induction cookers).
Batteries may explode if overheated.
If you have checked the above and the
appliance still does not charge, take it to a
Philips service center or contact the
Consumer Care Center.
English
51