Appendix A: Trouble Shooting & Support; A.1.1 Ups - Atlantis Onepower 700 Mode D'emploi

APPENDIX A: TROUBLE SHOOTING & SUPPORT
If the UPS is not functioning properly, you can refer first to this chapter for simple
troubleshooting before contacting your reseller. This could save you time and effort
but if the problem persist, then consult your service provider.

A.1.1 UPS

The LED and the acoustic signals are a profit tool to individualize immediately possible
problems
Situation
No LED display on the
front panel.
Alarm continuously
sounds when the mains
is normal.
Alarm sounds every 2
seconds when
mains is normal.
When power
back-up time
shorten.
Check Items
1. Low battery.
2. Battery fault.
3. The UPS is not turned on.
1. The UPS is overload.
2. UPS is fault
1. Battery defect.
the 2. Charging
damaged
fails, 1. The UPS is overload.
is 2. Battery voltage is too
low.
3. Battery defect. It might
be due to high
temperature operation
environment, or improper
1. Charge the UPS at least
2. Replace
3. Press the power switch
1. Remove some uncritical
2. Remove some uncritical
3. Contact Atlantis.
1. Replace
board is
2. Contact Atlantis.
1. Remove some critical
2. Charge the UPS at least
3. Replace
28
ENG
Solution
8 hours.
the battery
with the same type of
battery.
again to turn on the
UPS.
load.
load and re-switch on
the UPS.
the battery
with the same type of
battery.
load.
8 hours.
the battery
with the same type of
battery.